Serial Touchscreen System ================================== DOS Driver (V8.7x) Installation Note Date : Dec. 01/1998 ----------------------------------------- 1. Driver Installation : . Insert Disk 1 to the diskette drive. . Under DOS prompt : > a: > cd \dos > install x: y: x: --> source drive y: --> destination drive Example --> install a: c: 2. Load/Unload Driver : . Use "m.bat" to load and unload the driver. 3. Touchscreen Control Panel : . Use "s.bat" to run Touchscreen control panel for setting the touchscreen. . "Calibration" has to be done once right after the touchscreen driver is installed. Warning : The touch point and the cursor may not be consistent if the touchscreen is not calibrated. 4. Serial Port Configurtion : . Use "c.bat" to configure the serial ports. Windows 3.x Driver (V8.7x) Installation Note ------------------------------------------------ 1. Hardware configurations : The mouse has to be connected to the mouse port of touchscreen controller to work with touchscreen under windows 3.1. 2. Driver installation : . Connect the touchscreen to the system. . Run " a:\win31\setup.exe" from DOS or windows to install the driver. 3. Touchscreen Control Panel : . The touchscreen control panel is automatically added during driver installation. . Run Touchscreen control panel to configure the touchscreen. . "Calibration" has to be done once right after the touchscreen driver is installed. Warning : The touch point and the cursor may not be consistent if the touchscreen is not calibrated. 4. Assign Touchscreen : . The touchscreen driver could be re-assigned by running "Install TouchScreen 8.xx" which is automatically added during driver installation. 5. Uninstall Touchscreen Driver : . The touchscreen driver could be uninstalled by running "Uninstall TouchScreen 8.xx" which is automatically added during driver installation.