Installing the TouchWindow™ for Mac®

After downloading the TouchWindow™ driver for the Macintosh® USB TouchWindow™, installation steps are needed. Consult the remainder of this note for instructions to install the TouchWindow™ driver.

For Mac® OS 10, refer to the Installation for Mac OS® 10 Users section (BELOW). For all other versions of Mac®, continue with the steps presented below.
  1. Double-click the TouchWindow folder located on the desktop.
  2. Double-click the Mac OS 9 and earlier folder.
  3. Double-click the TSHARC-USB 1.06 Installer. The Installer window will appear.
  4. Click Continue.
  5. Click Agree to agree to the License Agreement.
  6. Click OK. A message will appear indicating that the installation is complete.
  7. Click OK to close this message. The Calibration Rev 1.05 window will appear.
  8. Select the desired calibration mode. The 3-point mode calibrates the TouchWindow® when the screen is touched at three various points to align the TouchWindow®. The 7-point mode calibrates the TouchWindow® when the screen is touched at seven various points to align the TouchWindow®.

    NOTE: Using the 7-point mode will result in a more accurate calibration.
  9. Click Calibrate.
  10. Follow the onscreen prompts to complete the calibration.
  11. When the calibration is complete, click the Test tab to test the calibration.
  12. Click the Draw button.
  13. Click and drag on the TouchWindow® to draw in the work area. (If the cursor does not appear where the screen is touched, perform the calibration again.)
  14. Once the calibration process is complete, close the TSHARC-USB Calibration window.
Installation for Mac OS® 10 Users
  1. Double-click the TouchWindow folder located on the desktop.
  2. Double-click the Mac OS X folder.
  3. Double-click the proedX104RC1.dmg file.
  4. Double-click the pro.ed TSHARC Touch Screen Installer 104.pkg file. A Welcome to the Installer window will appear.
  5. Click Continue. An Important Information window will appear.
  6. Click Continue. The Software License Agreement window will appear.
  7. Click Continue.
  8. Click Agree to agree to the Software License Agreement and continue with the installation.
  9. Select the desired destination disk and click Continue.
  10. Click the Upgrade button. A window will appear prompting for a username and password.
  11. Enter an administrative username and password at the prompt and click OK.
  12. Click Continue Installation.
  13. Once the installation is complete, click the Restart button to restart the computer.
 
 

 




 

 435-673-5455
 800-753-2441
 828-835-3322 Bryan NC
 770-921-8494 Fax

  Copyright © 2016

TouchWindow.com
Touch Screens Inc.
445 N. 1660 West Circle
St. George, Utah 84770 USA
Touch Screen, Elo Touch Screen, 3M Touch Screens, Industrial Touch Display Monitors
Home        Contact Us        Support        Site Map

 

                Secure Site