Touchwindow Hanger Arm Installation

This technical note includes the complete instructions for installing the new hanger arm system on a 17" TouchWindow®.

Installing the New Hanger Arm System on a 17" TouchWindow®
  1. Using the supplied Allen wrench, remove the feet (L-shaped piece of plastic at each corner) from the top of the TouchWindow®.
  2. Position the left and right hanger arms so they align with the holes used to attach the feet (Step 1).

    NOTE: Verify that the Velcro® insert faces away from the front of the TouchWindow® so that it can attach to the top of the monitor.
  3. Reinstall the feet using the screws that were removed in Step 1 (above).

    NOTE: Do not use the small screws included with the kit unless the TouchWindow® is attached to a true flat-screen monitor and the feet are not used.
  4. Place the supplied circular Velcro® fastener on top of the monitor.
  5. Position the hanger arms so that they attach to the Velcro® fastener on top of the monitor.
  6. Ensure that the original Velcro® strips shipped with the TouchWindow® are in place at each of the four corners.



 

 435-673-5455
 800-753-2441
 828-835-3322 Bryan NC
 770-921-8494 Fax

  Copyright © 2016

TouchWindow.com
Touch Screens Inc.
445 N. 1660 West Circle
St. George, Utah 84770 USA
Touch Screen, Elo Touch Screen, 3M Touch Screens, Industrial Touch Display Monitors
Home        Contact Us        Support        Site Map

 

                Secure Site